What is the drainage system of the shower room?

Our bathroom was generally flat and tidy, nothing special. As the society has developed a lot of new innovations in the design of bathroom floor tiles, let's take a look at the following reasons. Is it new? But what's the use of this? Let's take a look!

Explain to everyone first, the ordinary slotting process, this is very simple, and as shown on the map, the middle bath area is slightly higher, the surrounding is slightly lower, and the middle part is used A small piece of stone pulled out of a single groove, this can be conducive to drainage, but also anti-skid.

Many people use a single piece of marble as the material for the groove. There are also many people who are using such antique bricks. The effect is still quite good. It is only at this position of the tile joints that more work should be done.

In general, the pull grooves are various. The common ones are the ruled surface and the lattice surface. We also divide the lattice surface into a V-shaped groove and a concave groove. It can be said that the V-shaped drawing groove is the best type of drainage effect.

According to the analysis of various problems in different shower rooms, the following masonry shower room only needs to make a half-circle drainage groove on the side close to the glass. Then we can see that the flowing water flows in the same direction. This drainage effect will be better, and then do not worry about the accumulation of water when bathing.

This kind of drainage trough on all sides, of course, the effect is also very good.

This kind of square shower room only requires the middle part to be a little higher than the surrounding area. It can also be only half a circle, or it can be equipped with two floor drains. This kind of drainage effect will be better.

Does anyone worry that such a lot of cracks are not easy to filth? This is true and easy. Therefore, we must always remember to wash, but it is still recommended to use marble, because the gap in the tile is indeed a bit more. When laying, the most important thing is to grasp the angle and slope, which will help expel the water faster!